WFO is a new kind of elevator balance compensating chain with excellent performance, it can ensure the elevator working under an ideal and stable state.

Seen from structure, it is the perfect combination of electric-welding anchor chain and composite material PVC. It has unique functions and has the following strong traits: greater elasticity, smaller bending radius, flame-resistant, anti-aging, wider temperature adaption range, etc. After using this kind of compensating chain, the operation of your elevator will be stable and smooth, and working with low noise. WFO is used for elevator with rated speed of higher than 1.75m/s.

1.Before installation, it is necessary to straighten the compensating chain, in order to prevent the rubber or plastic from being cracked or peeled by twisting during working.

2. The way to eliminate: After hanging the compensating chain at the bottom of the car, run the elevator to the top slowly,then measure the required length, cut off, roll and warp the length left on the ground, keep it over 1meter from the ground, and hang it for 24 hours statically, till all spirals is released, and then hang another side. After several days of elevator's working, recheck whether there is any spiral, do it again.

3. The center line of the dampening device should be kept in the same vertical line with the hanging point, to prevent any accidental breakdown caused by the friction between the compensation chain and the guiding device.

4. The minimum distance between the installation point of the dampening device and the bottom of the loop of the compensating chain is one meter, to prevent the broken of the compensation chain caused by little bending radius.